EasyManuals Logo
Home>Epiroc>Cutter>ER-L Series

Epiroc ER-L Series User Manual

Epiroc ER-L Series
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Safety and operating instructions
14 © Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
2.13 Emissions, precautions
WARNING Noise hazard
Operating the hydraulic attachment creates a loud noise.
Long term high sound pressure level can affect your
hearing.
u Wear suitable hearing protection.
WARNING Lung disease
Dust may be generated when operating the hydraulic at-
tachment. If dust from rocks or silica dust, produced
when operating the hydraulic attachment on rocks, con-
crete, asphalt or other such materials, is inhaled this
may lead to silicosis (dust lungs, a severe lung disease).
Silicosis is a chronic disease which may lead cancer and
death.
u Wear a suitable breathing mask.
WARNING Vibration hazards
When working with the drum cutter severe vibrations can
occur and may cause considerable significant injuries
and chronic damage to health.
u Operate the drum cutter with a constant load, in or-
der to minimise existing vibrations.
u Avoid abrupt starting up or stopping of the cutter
drums.
WARNING Risk of death if exhaust gases are not
vented
When working in buildings or tunnels, exhaust gases
from the carrier (diesel motor) can collect and cause poi-
soning or even death.
u Effectively vent exhaust gases from buildings or tun-
nels using a ventilation system.
u Keep the cabin doors of the carrier closed.
WARNING Hot surfaces
The cutter drums of the drum cutter can become very
hot in operation. Skin contact with hot surfaces results in
severe burns to the skin.
u Always wear heat-resistant protective work clothes
and protective gloves, when working in close proxim-
ity to hot surfaces.
u Prior to all work, check the drum cutter to ensure that
all surfaces have cooled to the ambient temperature.
2.14 Handling machines,
precautions
WARNING Injuries due to incorrect operation
Incorrect operation can result in severe injuries and may
cause considerable damage to property.
u Carry out all operating steps in accordance with
these Safety and operating instructions.
u Prior to starting work, ensure that:
- All covers and safety devices are installed and are
fully functional.
- No persons are in the hazardous area.
u Never switch off any safety devices during opera-
tions or bridge these.
WARNING Injuries due to unclean workplace
A dirty workplace can cause accidents and may result in
severe injuries.
u Always keep the accesses to the carrier cabin clean.
u Always keep the cabin windows clean.
u Do not leave parts or objects lying around the work-
ing area.
WARNING Injuries due to missed inspection and
repair work
Disregarding or neglecting daily inspections can result in
serious accidents and lead in turn to the severe injuries
associated with them.
u Carry out all daily inspections before and after work.
u Report any faults or damage to maintenance person-
nel immediately and instruct them to repair them.
u Only restart the carrier once the fault or damage has
been repaired.
WARNING Narcotics, alcohol and drugs
Narcotics, alcohol and medicinal drugs make their users
less alert and affect their ability to concentrate. Negli-
gence and incorrectly assessing a situation can result in
serious injury or death.
u Never work on or with the hydraulic attachment when
under the influence of narcotics, alcohol or drugs
which affect your alertness.
u Never allow other people who are under the influ-
ence of narcotics, alcohol or drugs which affect their
alertness to work on or with the hydraulic attach-
ment.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epiroc ER-L Series and is the answer not in the manual?

Epiroc ER-L Series Specifications

General IconGeneral
BrandEpiroc
ModelER-L Series
CategoryCutter
LanguageEnglish