Epiroc ER-L Series User Manual

Safety and operating instructions
52 © Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
7.10.2 Replace round attack pick with
retaining sleeve
The following special equipment is required to replace
the round attack picks:
• Puller(E) for pick with retaining sleeve
The special equipment is included in the scope of deliv-
ery.
The round attack pick has a notch (see arrow).
1.
Slide the puller(E) into the notch of the round attack
pick with the impact surface(F) directed to the cutter
drum.
E
F
2.
Grip the puller(E) firmly in the hand.
3.
Give the impact surface(F) of the puller(E) a forceful
blow with a hammer.
The round attack pick will loosen from the pick box.
4.
Pull round attack pick out of the pick box.
5.
Clean the pick box.
6.
Place a new round attack pick(G) in the notch of the
puller. The tip of the pick must point in the direction of
the impact surface(F).
G
F
7.
Place the new round attack pick in the puller and
place in the opening of the pick box(H).
H
F
8.
Give the impact surface(F) of the puller a forceful
blow with a hammer.
The round attack pick is anchored in the pick box by
the retaining sleeve on the shaft.

Epiroc ER-L Series Specifications

General

Brand	Epiroc
Model	ER-L Series
Category	Cutter
Language	English