Epiroc ER-L Series - Dismount Hexagonal Receiver and Intermediate Flange

Safety and operating instructions
36 © Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
5.6.6 Dismount hexagonal receiver and
intermediate flange
not for ERL 700, ERl 1100
n
Lift the drum cutter using suitable lifting equipment
and suspend on a crane. Observe the weight (see
chapter Technical Specifications).
n
Place the drum cutter upright down a level working
area.
n
Secure the upright drum cutter against toppling by
suitable means.
n
Remove the facing screws from the disassembly
screw apertures of the hexagonal receiver(M).
n
Remove the fastening screws(N) from the hexagonal
receiver and screw into the disassembly screw aper-
tures.
By tightening the fastening screws(N) into the disas-
sembly screw apertures the hexagonal receiver will
slowly push up from the intermediate flange.
n
Remove the hexagonal receiver(M).
n
Remove the facing screws from the disassembly
screw apertures of the intermediate flange(J).
n
Remove the fastening screws(L) from the intermedi-
ate flange and screw into the disassembly screw
apertures.
By tightening the fastening screws(L) into the disas-
sembly screw apertures the intermediate flange will
slowly push up from the drive shaft.
n
Remove the intermediate flange(J).
n
Place the hexagonal receiver(M) and intermediate
flange(J) on a pallet for further use and secure
against falling off.
n
To reattach the cutter drum see chapter Assemble
cutter drum.