o
Have you optimized the temperature and
pressure of the heat press?
The temperature of the heat press decreases when
you press a T-shirt that has had pre-treatment liquid
applied. When pressing several T-shirts one after
another, check that the temperature of the heat press
is not lower than required. Also, the whiteness
becomes uneven if the pressure is insufficient since
the T-shirt does not dry completely and the fibers are
not pressed flat. Make sure you optimize the pressure
of the heat press.
U “Fixating the Pre-treatment Liquid (Heat Press)”
on page 35
o
Try washing the ink tubes.
Because sedimentation occurs easily in White ink, the
whiteness may decline or become uneven if you
continue printing in white. Prepare the following
consumables when washing the tubes.
❏ White ink cartridges x2
❏ Cleaning cartridges x2
❏ Waste ink bottle
U “Options and Consumable Products” on
page 114
U “Tube Washing” on page 91
The under-base white is showing
outside the image
o
Adjust the print area of the under-base white
in the software.
The printed under-base white may show outside the
image depending on the material of the T-shirt and
the amount of ink fired. If this occurs, adjust the print
area of the under-base white from the printer's
Garment Creator software or the RIP software.
Others
The control panel display keeps
turning off.
o
Is the printer in sleep mode?
Normal operation can be restored by pressing any of
the buttons in the control panel to reactivate the
display and then performing a hardware operation
such as opening the printer cover or sending a job to
the printer. You can select the time for shifting to sleep
mode from the Administrator Menu.
U “Menu List” on page 96
Printing does not stop or printed text
is corrupted
o
Have you started Garment Creator and
software RIP over a USB connection?
Only start Garment Creator or software RI P. Do no t run
them both at the same time.
SC-F2100 Series User's Guide
Problem Solver
111
To Next Page
Loading...
Need help?
General