Fronius MagicWave 3000 User Manual

TIG welding parameters for 2-step mode
TIG welding parameters for 4-step mode
Welding paramet-
ers in the cold
wire setup
"Minimum" and "maximum" are used for setting ranges that differ according to power
source, cold wire-feed unit, welding program, etc.
Wirefeed spd2
Wire feed speed 2
Unit % (of the wire feed speed)
Setting range 0 - 100
Factory setting 50
If a value is set for both 'wire feed speed 2' and 'pulse frequency', then the wire feed
speed alternates between the following values in sync with the pulse frequency of the
welding current:
- Wire feed speed from the TIG welding parameters
- Wire feed speed 2
Start-delay
Delay in the start of wirefeeding from beginning of the main current phase
Unit s
Setting range OFF / 0.1 - 9.9
Factory setting OFF
End-delay
Delay in the start of wirefeeding from end of the main current phase
Unit s
Setting range OFF / 0.1 - 9.9
Factory setting OFF
Wire threading
Wire threading speed
Unit m/min ipm.
Setting range 1,0 - max. 39.37 - max.
Factory setting 5 197
124

Fronius MagicWave 3000 Specifications

General

Brand	Fronius
Model	MagicWave 3000
Category	Portable Generator
Language	English