Fronius MagicWave 3000 User Manual

2-step mode - Welding: Pull back and hold the torch trigger
- End of welding: Release the torch trigger
NOTE!
To work in 2-step mode after it has been selected, the SPt setup parameter must
be set to "OFF" and the spot welding indicator on the control panel must not light
up.
I
t
I
1
G-L / G-HGPr t
up
t
down
I
S
GPr t
E
I
E
t
S
G-L
G-H
2-step mode
... Manual application ... Automatic application
Spot welding If a value has been set for the SPt set-up parameter, 2-step mode will have the spot
welding mode function. The special spot welding indicator on the control panel will light
up.
- Welding: briefly pull back the torch trigger
The welding time corresponds to the value set for the SPt set-up parameter.
- to end the welding process prematurely: pull the torch trigger back again
When using a pedal remote control, the spot welding time starts when the pedal remote
control is operated. The power cannot be controlled using the pedal remote control.
46

Fronius MagicWave 3000 Specifications

General

Brand	Fronius
Model	MagicWave 3000
Category	Portable Generator
Language	English