4-20 MAC 5500 resting ECG analysis system Revision E
2020299-020
Troubleshooting: Frequently Asked Questions
Frequently Asked Questions
Maintenance
NOTE
See Operator’s Manual for complete System Setu
p information.
Save Setups
Q: How do I save changes I have made to the System Setups?
A: Check the following:
Return to Menu by pressing the esc key or selecting More from the menu
until you see System Setup.
Select System Setup.
Select Save Setup.
Select To System.
You can select Main Menu to exit System Setup.
Storing ECGs
Q: Why won't any of the ECGs I perform save to the SD card?
A: Check the following:
Check that the SD card is fully inserted into the drive.
Make sure you are using 64 MB SD cards.
Verify that the SD card is not write-protected.
Try a new SD card.
If your system is not set up to automatically save records, you must
manually save by pressing Store.
Format an SD Card
Q: How do I format an SD card in the MAC 5500?
A: Most secure digital cards do not require formatting. In the event an unformatted
SD
card is used with the system, the following message will display:
This SD Card cannot be read and requires formatting. Formatting will
destroy all data
on this SD Card. Are you sure you want to format?
Select Yes
to format the SD card.
Cleaning
Q: Should I clean the MAC 5500?
A: Clean the exterior surfaces of all the equipment and peripheral devices monthly,
or more frequ
ently if needed.
Use a clean, soft cloth and a mild dishwashing detergent diluted in water.
Wring the excess water from the cloth. Do NOT drip water or any liquid on
the writer assembly, and avoid contact with open vents, plugs, and
connectors.
To Next Page
Loading...
Need help?
General
