Tools | Tool data
6
234
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Entering tool data into the table
You can define and store up to 32 767 tools and their tool data in a
tool table. Also see the editing functions later in this chapter.
You must use tool tables if:
you wish to use indexed tools such as stepped drills with more
than one length compensation value
Further information: "Indexed tool", page 235
your machine tool has an automatic tool changer
you want to work with the machining cycle 22,
Further information: Cycle Programming User's Manual
you want to work with machining cycles 251 to 254,
Further information: Cycle Programming User's Manual
NOTICE
Caution: Data may be lost!
Deleting line 0 from the tool table will destroy the structure of
the table. As a result, locked tools might no longer be recognized
as locked and, consequently, the search for a replacement
tool will not work, either. The problem cannot be solved by
reinserting a line 0. The original tool table will be permanently
damaged!
Restore the tool table
Add a new line 0 to the defective tool table
Copy the defective tool table (e.g. toolcopy.t)
Delete the defective tool table (current tool.t)
Copy the copied tool table (toolcopy.t) as tool.t
Delete the copied tool table (toolcopy.t)
Contact HEIDENHAIN Service (NC helpline)
All table names must start with a letter. Please keep this
in mind when creating and managing additional tables.
You can select the table view with the Screen Layout
key. You can choose between a list view and a form
view.
Other settings, such as HIDE/ SORT/ COLUMNS, can be
made after the file is open.
To Next Page
Loading...
Need help?
General
