Test Run and Program Run | Graphics (option 20)
18
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
709
Measurement of machining time
Machining time in the Test Run operating mode
The control calculates the duration of the tool movements and
displays this as machining time in the test run. The control takes
feed movements and dwell times into account.
The time determined by the control is only of limited value for
calculating the machining time because it does not take any
machine-dependent time intervals (e.g., for tool changes) into
consideration.
Machining time in the machine operating modes
Time display from program start to program end. The timer stops
whenever machining is interrupted.
Selecting the stopwatch function
Shift the soft key menu until the soft key for the
stopwatch functions appears
Select the stopwatch function
Select the desired function via soft key,
e.g.,saving the displayed time
Soft key Stopwatch functions
Store displayed time
Display the sum of stored time and displayed
time
Clear displayed time
To Next Page
Loading...
Need help?
General
