Operating the Touchscreen | Functions in the taskbar
3
142
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
3.3 Functions in the taskbar
Touchscreen Calibration
With the Touchscreen Calibration function you can measure and
correct the screen.
Calibrating the touchscreen
Proceed as follows to conduct the functions:
Use the DIADUR icon to open the HeROS menu
Select the Touchscreen Calibration menu item
The control starts the calibration mode.
Successively tap on the blinking symbols
If you would like to stop the calibration:
Press the ESC key
Touchscreen Configuration
With the Touchscreen Configuration function you can define the
properties of the screen.
Adjusting sensitivity
Proceed as follows to adjust the sensitivity:
Use the DIADUR icon to open the HeROS menu
Select the Touchscreen Configuration menu item
The control opens a pop-up window.
Select the sensitivity
Confirm with OK
Display of the touch points
Proceed as follows to show or hide the touch points:
Press the DIADUR key to open the JH menu
Select the Touchscreen Configuration menu item
The control opens a pop-up window.
Select the Show Touch Points display
Disable Touchfingers to hide the touch points
Enable Single Touchfinger to show the touch point
Enable Full Touchfingers to show the touch points of all
fingers involved
Confirm with OK
To Next Page
Loading...
Need help?
General
