Programming Contours | Path contours – FK free contour programming
7
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
321
Free straight line programming
Straight line without tangential connection
To display the soft keys for free contour
programming, press the FK key
To initiate the dialog for free programming of
straight lines, press the FL soft key
The control displays additional soft keys.
Enter all known data in the block by using these
soft keys
The FK graphic displays the programmed contour
element in violet until sufficient data is entered.
If the entered data describes several solutions,
the graphic will display the contour element in
green.
Further information: "FK programming
graphics", page 319
Straight line with tangential connection
If the straight line connects tangentially to another contour
element, initiate the dialog with the FLT soft key:
To display the soft keys for free contour
programming, press the FK key
To initiate the dialog, press the FLT soft key
Enter all known data in the block by using the
soft keys
To Next Page
Loading...
Need help?
General
