Programming Aids | Freely editing an NC program
5
210
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
5.2 Freely editing an NC program
Certain syntax elements, such as LN blocks, cannot be entered
directly in the NC editor by using the available keys and soft keys.
To prevent the use of an external text editor, the control offers the
following possibilities:
Free syntax input using the control's integrated text editor
Free syntax input using the ? key in the NC editor
Free syntax input using the control's integrated text editor
Proceed as follows to add syntax to an existing NC program:
Press the PGM MGT key
The control opens the file manager.
Press the MORE FUNCTIONS soft key
Press the SELECT EDITOR soft key
The control opens a selection window.
Select the TEXT EDITOR option
Confirm your selection with OK
Add the desired syntax
The control does not check the syntax in the text editor.
Check your entries in the NC editor when you are
finished.
Free syntax input using the ? key in the NC editor
Proceed as follows to add syntax to an existing, open NC
program:
Enter ?
The control opens a new NC block.
Add the desired syntax
Confirm your entry with END
After confirmation, the control checks the syntax. Errors
will result in ERROR blocks.
To Next Page
Loading...
Need help?
General
