Control Panel User Manual
33
No Tampering
Prevention
Recovery Report
With Tampering
Prevention Recovery
Report
{12} End the command.
3.1.4 Telco Line Communication Control
The communication control command is used for setting the phone
connection mode of alarm center 1 and 2. The detailed command is shown
below.
{1} The Telco line communication control programming address: 457
{2} Dialing Mode of Telephone Center1
{3} Dialing Mode of Telephone Center2
DTMF- double
tone&
multi-frequency
(5/sec)
DTMF- double
tone&
multi-frequency
(10/sec)
{4} Dialing Times of Telephone Center1
{5} Dialing Times of Telephone Center2