Control Panel User Manual
49
{5} End the command.
3.1.24 Partition Configuration
Partition Start-up Configuration
The programming command of the partition start-up configuration is shown
below.
{1} The programming of partition start-up configuration is: 531～538.
{2} The configuration item of 1 indicates the start-up configuration of
the partition.
{3} Enable/Disable the Partition.
{4} End the command.
Only the No.1 partition is enabled as the default settings.
Partition Keypad User Configuration
The programming command of keypad user configuration of the partition
is shown as follows.
To Next Page
Loading...
Need help?
General
