Control Panel User Manual
38
{6} End the command.
After successfully operating once, you can continuously do configuration with
the command of {Project} + { Trigger No.} + {System Command.} + {Event
Command} + {#}.
3.1.9 Trigger Time Settings
For Trigger output time settings, please refer to the command below.
{1} Trigger Time Programming Address: 470
{2} Trigger No.
{3} Duration: In minute
{4} Duration: In second
{5} End the command.
The maximum duration of triggering is 99 minutes and 59 seconds. The default
duration is 30 seconds.
After operating once, you can continuously configure with the command of
{Project} + {Trigger No.} + {Duration} + {#}
To Next Page
Loading...
Need help?
General
