HIKVISION DS-9000 Series User Manual

DS-7700NI-SP/9000/9600 Series HDVR/NVR User’s Manual
25
Setting Date & Time
It is extremely important to setup the system date and time to accurately timestamp recordings and events.
To setup date and time as following steps:
Steps:
1. Enter the System Configuration menu by going to Menu > System Configuration > General.
2. Select the Time/Date tab, as shown in Figure 13.
Figure 13 System Configuration Menu
3. The current system time and date as well as the time zone will be displayed. Using the directional
buttons on the front panel/remote or the mouse, select the correct date, time and time zone.
4. To enable Daylight Savings Time, click and check the Enable DST checkbox and there will pop-
up the DST Setting menu, as shown in Figure 14. You can check the Auto DST Adjusting
checkbox or manually check the date of the DST period and click the Apply button to confirm the
setting. Click the OK button to return to the up level menu.
Figure 14 DST Settings Menu

HIKVISION DS-9000 Series Specifications

General

Model	DS-9000 Series
Operating System	Embedded Linux
Operating Humidity	10% to 90%
Video Output	HDMI, VGA
Compression	H.264, H.265
Storage Capacity	Up to 10TB HDD per slot
Network Interface	10/100/1000Mbps Ethernet
Power Supply	100-240V AC
RAID	RAID 0, 1, 5, 10
USB Interface	USB 2.0
Operating Temperature	-10°C to +55°C

Summary

Chapter 2: Getting Started

Starting and Shutting Down Your DVR

Covers the correct procedures for powering the DVR/NVR on and off to ensure longevity.

Chapter 4: Record Settings

Configuring Settings for Recording

Covers the initial setup for recording quality, stream type, resolution, and bitrate.

Configuring Record Schedule

Details how to set up time-based schedules for continuous or event-triggered recording.

Chapter 5: Playback

Playing Back a Recording

Chapter 6: Backup

Backing up Video Clips

Chapter 7: System Configuration

Configuring Network Settings

Covers essential network configurations like IP addressing, DHCP, and working modes.

Managing User Accounts

Configuring Alarms and Exceptions

Chapter 8: Camera Management

Adding and Removing IP Cameras

Instructs on how to add, configure, and manage IP cameras connected to the system.

Chapter 9: RAID Configuration

Configuring Array and Virtual Disk

Covers creating RAID arrays and virtual disks for storage management.

Chapter 10: Disk Management

Formatting Disk

Chapter 11: DVR Management

Managing System