DS-7700NI-SP/9000/9600 Series HDVR/NVR User’s Manual
68
NO-IP:
1) Enter Server Address for NO-IP.
2) Enter the domain obtained from the DynDNS website (www.no-ip.com) in the Domain
Name textbox.
3) Enter the User Name and Password registered in the NO-IP website.
hkDDNS:
1) The Server Address defaults to www.hik-online.com.
2) Enter the Device Domain Name. The domain name can only contain the lower-case letter,
numeric and ‘-’, and it must start with the lower-case letter and cannot end with ‘-’.
3) If you have more than one device, you can register an account on www.hik-online.com to
do some management.
4. Click the Apply button to save the settings.
Configuring SNMP
You can use SNMP protocol to get device status and parameters related information. To configure SNMP:
1. Select the SNMP tab to enter the SNMP settings interface, as shown in Figure 65.
Figure 65 SNMP Settings Menu
2. Check the Enable SNMP checkbox.
3. Enter the IP address of SNMP host in the Trap Address textbox.
4. Enter the port of SNMP host in the Trap Port textbox
5. Click the Apply button to save the settings.
Configuring UPnP
Universal Plug and Play (UPnP) can permits the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP function to enable the fast connection of the device to
the WAN via a router without port mapping. To configure UPnP:
1. Select the UPnP tab to enter the UPnP settings interface, as shown in Figure 66.
To Next Page
Loading...
Need help?
General