16 Volara™ System, Model PVL1 User Manual (196286 REV C)
Assemble and Connect the Patient Circuit
ASSEMBLE AND CONNECT THE PATIENT CIRCUIT
WARNING:
To help prevent injury and/or equipment damage, obey these warnings:
• Warning—Do not operate the system unless a bio-filter is
attached to the system.
• Warning—Do not use excessive force when assembling or
disassembling the patient circuit. This helps to avoid damage to
the components.
• Warning—To avoid cross-contamination, always use a new
patient circuit when using the system on a new patient.
• Warning—Discard the circuit in accordance with facility
protocols.
• Warning—Do not attempt to sterilize the circuit for reuse.
NOTES:
• Each patient circuit is for use by a single patient and intended for 30
days of treatment or a maximum of 90 treatment sessions.
• If the circuit and/or bio-filter are damaged or visibly soiled, replace
them. See “Replacement Parts/Kits” on page 78.
• The system keeps a log of the number of use cycles for the patient
circuit. If a patient circuit is used beyond its recommended usable life,
the system notifies the user.
For assistance with setup, use, or maintenance of the system, contact Hill-
Rom:
• In the USA, call Hill-Rom at 800-426-4224.
• Outside the USA, contact your distributor or local Hill-Rom
representative, or go to www.respiratorycare.hill-rom.com.
Connect the correct patient circuit. See page 17.
196654__C_2019-Apr-29_Cleaned
To Next Page
Loading...
Need help?
General
