Volara™ System, Model PVL1 User Manual (196286 REV C) 85
Maintenance
MAINTENANCE
WARNING:
Warning—To prevent injury and/or equipment damage, do not do
maintenance when the system is in use.
INLET FILTER
Examine the inlet filter every month, and clean it as necessary. Replace the
inlet filter every twelve (12) months.
To clean the filter, do as follows:
1. Power off the control unit.
2. Remove the inlet filter from the back of the control unit.
NOTE:
If the filter is damaged, replace it. See “Replacement Parts/Kits” on
page 78.
3. Wash the filter with mild detergent and warm water, and then rinse it
with clean water.
4. Allow the filter dry completely, and then install it into the back of the
control unit.
See
196654__C_2019-Apr-29_Cleaned