24 Volara™ System, Model PVL1 User Manual (196286 REV C)
Set up and Power on the Control Unit
SET UP AND POWER ON THE CONTROL UNIT
Warning—Never block the air openings of the system or set it on a soft
surface, such as a bed or couch, where the air openings may be blocked.
Keep the air openings free of lint, hair, and the like. Otherwise, patient
injury could occur.
NOTES:
• If the control unit is taken out from storage, do the following before
use:
– Allow the control unit to warm up in an ambient
environment of 68°F (20°C) for at least 45 minutes when
removed from a storage temperature of -4°F (-20°C) or
colder.
– Allow the control unit to cool down in an ambient
environment of 68°F (20°C) for at least 80 minutes when
removed from a storage temperature of 140°F (60°C) or
warmer.
• If the control unit is on the cart, make sure the casters are set. For
instructions on mounting the control unit on the cart, see page 71.
1. Set the control unit on a dry, flat, and hard surface. Make sure the
control unit is away from curtains, blankets, or any heat-generating
devices.
2. Follow the steps that apply to the power
source used:
• AC power—
a. Connect the power cord to the
back of the control unit.
b. Connect the other end to an
applicable power outlet.
NOTE:
The power cord shown is for illustrative purposes and may differ from
the one required for your country.
• Battery power—insert the battery into the battery
compartment on the back of the control unit.
3. Press and hold the Power button on the
control unit for 5 seconds.
196654__C_2019-Apr-29_Cleaned
To Next Page
Loading...
Need help?
General
