5.7 Warning Messages
● If any communication is in error, the associated warning message appears below the status display area.
● Note the message to confirm the error and then take remedial action as appropriate for the indicated error
code.
Error code table
Error
code
Name Description Check
001
Transmissioncode
error
● The transmitted code was not defined
for communication use.
● The transmitted message had an illegal
structure.
Check the baud rate and transmission
code.
002
Print specifications
code error
The print specifications data value was
illegal.
Check the print specifications
communication text.
003
Print character code
error
The maximum value was exceeded by
the number of characters for printings
that could be received as one item.
Check the printings communication text.
004 Item number error The item number code value was illegal. Check the printings communication text.
005 Header error The header value was illegal. Check the header.
006
Ready-for-
reception error
● An attempt was made to establish
communication while the "not ready
for reception" state prevailed.
● "Apply" key and message window
were both displayed.
● "Off-line fixed" has been set in
Communication environment.
● Communication monitor screen was
displayed.
● Communication was conducted during
the stop or shutdown process.
Check the transmission timing.
008
Print specifications
code error
The maximum value was exceeded by
the print specifications data.
Check the print specifications
communication text.
009 ETX code error The ETX code position was illegal.
Check the transmission procedure and
ETX code.
010 DLE code error The DLE code position was illegal.
Check the transmission procedure and
DLE code.
011 STX code error The STX code position was illegal.
Check the transmission procedure and
STX code.
012 ENQ code error The ENQ code position was illegal.
Check the transmission procedure and
ENQ code.
013
ESC code error
(ESC, ESC2)
The ESC code position was illegal.
Check the transmission procedure and
ESC code.