7-2 ●Maintenance service
Replacing the air filter
Trun off the power.
1
Loosen the knobs (thumb screws) and remove the intake fan cover.
2
Remove the old filter and set the new filter.
(Please set the new filter with red-mark being invisible.)
3
Intake fan cover
Knob (thumb Screw)
Red-mark inside
Air filter
Set the intake fan cover. (Turn the knobs until the intake fan cover comes into
contact with the printer.)
4
Printer
Turn the knob (Thumb screws) until comes into contact.
To Next Page
Loading...
Need help?
General
