4.14 Set the print specifications
4.14.1 Set the character height, character width, and orientation
(1) Function
●Sets the character height, character width, character orientation, and print start.
Character height
●The character height can be specified.
1
3
Ink drop use percentage setting Character width setting
1/1 002
1/2 001
1/3 to 1/16 000
●For rotary encoder wiring and setup, see the Technical Manual “4.3.2-1 Rotary encoder
specifications, wiring and switch setting”.
Ink drop use percentage
●Sets the ratio of drops used in printing. For example, ink drop use 1/3 prints at a ratio of 1 in 3 ink
drops. The 2 ink drops are recovered from the gutter.
2
Setting range of ink drop use percentage
Model type 1 line 2 lines 3 lines 4 lines 5 lines 6 lines Notes
UX-B 1/3 to 1/16 1/3 to 1/16 1/4 to 1/16 - - - -
UX-D 1/2 to 1/16 1/2 to 1/16 1/2 to 1/16 1/3 to 1/16 1/3 to 1/16 1/3 to 1/16 Option : Up to 1/1
UX-E 1/1 to 1/16 1/1 to 1/16 1/1 to 1/16 1/1 to 1/16 1/3 to 1/16 1/3 to 1/16 -
●When ink drop use is 1/1 or 1/2, high speed printing is possible. For ink drop use 1/16, low speed
printing is performed and the print quality improves.
●When Format setup is Free layout on the Change message screen, setting range of ink drop use
percentage is 1/2 to 1/16.
●When a character size 30
× 40 or 36 × 48 print item was set, the settable ink drop use percentage
becomes 1/5 to 1/16.
Character width
●The character width can be specified.
●The character width setting range is from 0 to 3999.
●When the product speed matching feature is incorporated (when the rotary encoder is connected),
set the character width as indicated below.
Changes the print start
delay input units.
Screen
switching
To Next Page
Loading...
Need help?
General
