Honda BF8D User Manual

〈〉
125
Tank Filter Cleaning EMISSION CONTROL SYSTEM
(For Bodensee-Lake type)
MAINTENANCE
FUEL TANK FILTER JOINT
(Fuel Hose Connector)
CONNECTOR
GASKET
5 mm SCREWS
FUEL TANK FILTER
Problems that May Affect Outboard
Motor Emissions
If you are aware of any of the
following symptoms, have the
outboard motor inspected and
repaired by your authorized Honda
Dealer:
The combustion process produces
carbon monoxide and hydrocarbons.
Control of hydrocarbons is very
important because under certain
conditions, they react to form
photochemical smog when subjected
to sunlight. Carbon monoxide does
not react in the same way, but it is
toxic. Honda Motor Co., Ltd. utilizes
lean carburetor settings and other
system to reduce carbon monoxide
and hydrocarbons.
Rough idle
Poor performance (driveability)
and poor fuel economy
Misfiring or backfiring during
acceleration
Hard starting or stalling after
starting
Remove the four 5 mm screws
using a flat screwdriver, then
remove the fuel hose connector
and fuel tank filter from the tank.
Clean the filter in nonflammable
solvent. Inspect the fuel tank filter
and the connector gasket. Replace
them if damaged.
Reinstall the filter and hose
connector in the fuel tank. Tighten
the four 5 mm screws securely.
1.
3.
4.
1.
2.
2.
3.
11/09/05 18:16:58 32ZY0620_125

Honda BF8D Specifications

General

HP Rating	8 HP
Cooling System	Water cooled
Fuel Delivery	Carburetor
Ignition System	CDI
Starting System	Manual
Gear Ratio	2.33:1
Fuel Tank Capacity	12 L (external tank)
Engine Type	4-stroke
Full Throttle RPM Range	5, 000-6, 000 RPM
Shaft Length	381 mm (Short Shaft)