If the emergency stop switch
lanyard is not set, the boat
might run out of control when
the operator, for example, falls
outboard and not able to
operate the outboard.
60
STARTING THE ENGINE (H type)
Starting the Engine
The propeller must be lowered into
the water, running the outboard
motor out of the water will damage
the water pump and overheat the
engine.
EMERGENCY STOP
SWITCH LANYARD
ENGINE STOP
SWITCH
EMERGENCY STOP
SWITCH CLIP
STOP
The engine does not start unless the
emergency stop switch clip is set on
the engine stop switch.
Store the spare emergency stop
switch clip in the tool bag. Use the
spare emergency stop switch clip to
make the emergency engine start
when the emergency stop switch
lanyard is not available as, for
example, the operator falls outboard.
Engage the emergency stop switch
clip (located at one end of the
emergency stop switch lanyard)
with the engine stop switch.
Attach the other end of the
emergency stop switch lanyard
securely to the operator.
For the sake of the operator’s and the
passengers’ safety, be sure to set the
emergency stop switch clip and
attach one end of the emergency stop
switch lanyard securely to the
operator.
1.
11/09/05 18:05:23 32ZY0620_060
To Next Page
Loading...
