×
56
Check the following items:
Other Checks
The possibility of corrosion
damage is increased if the anode
metal is painted over or allowed to
deteriorate.
PRE-OPERATION CHECKS
(1)
(2)
TOOL KIT
STARTER ROPE
OWNER’S MANUAL
PLIERS
10 mm SOCKET WRENCH
SPARK PLUG WRENCH
TOOL BAG
OIL CHECK SCREWDRIVER
FLAT SCREWDRIVER
SCREWDRIVER GRIP
8 mm WRENCH
PHILIPS SCREWDRIVER
10 12 mm WRENCH
4 mm HEX. WRENCH
The fuel hose for kinking,
collapsing or a loose connection.
The stern bracket for damage and
clamp screw tightened.
The anode metal helps to protect the
outboard motor from corrosion
damage; it must be exposed directly
to the water whenever the outboard
motor is in use. Replace the anodes
when they have been reduced to
about two-thirds of their original size,
or if they are crumbling.
The anode metal for damage,
looseness or excessive corrosion.
The tool kit for missing spare
parts and tools.
Other parts/materials required by
laws/regulations.
Spare emergency stop switch clip.
Spare Plug(s), engine oil, Spare
propeller, Cotter pin(s).
Tool kit
Owner’s Manual
Parts/materials which should be
installed on board:
The remote control lever and
switch for operation (R type).
The tiller handle for loose
installation, wobble, or operation
(H type).
(1)
(3)
(4)
(2)
(5)
(1)
(6)
(2)
(3)
(4)
(5)
11/09/05 18:04:48 32ZY0620_056
To Next Page
Loading...
Need help?
General
