Honeywell ECS Series User Manual

LS10143-001SK-E Programming Overview
8-4
8.2 Mapping Overview
This section of the manual is a high level overview of mapping.
Mapping is an important concept with the control panel. In general terms, mapping is assigning or linking events
to outputs that will activate when events occur. You do this by assigning input points to input zones, output points
to output groups and then linking or mapping zones and output groups.
Figure 8-1 is a brief overview of the concept of mapping. The next several pages of the manual show these
subjects in detail.
Figure 8-1 Mapping Overview
Note: Supervised notification Outputs mapped to General troubles on the NAC circuit should be made latching.
Failing to do so will cause the circuit to continually cycle into and out of trouble until silenced or restored,
if that circuit goes into trouble with an open of short condition.

Honeywell ECS Series Specifications

General

Brand	Honeywell
Model	ECS Series
Category	Conference System
Language	English