LS10143-001SK-E Control Panel Installation
4-18
4.7 RA-100 Remote Annunciator Installation
The optional Model RA-100 Remote Annunciator, is shown in Figure 4-24. The RA-100 can be surface or flush
mounted. Up to 31 annunciators can be added to the IFP-2100 system in any combination.
Figure 4-24 Model RA-100 Remote Annunciator, Front View
RA-100 installation involves the following steps:
1. Ensure power is turned off at the panel.
2. Mount the RA-100 in the desired location (see Section 4.5.1).
3. Connect the RA-100 to the panel (see Section 4.7.2).
4. Use the DIP switches on the back of the RA-100 to assign an ID number to the RA-100 (see Section 4.13.1).
5. The RA-100 module must be added to the system through programming. JumpStart will add the module
automatically (see Section 8.1). You can also add it manually (see Section 9.2.2). Select a name, if desired
(see Section 9.2.1.2).
4.7.1 Mounting the RA-100
This section of the manual describes mounting the remote annunciator. The annunciator can be flush- or surface-
mounted.
4.7.1.1 Flush Mounting
This section of the manual describes flush mounting.
Follow these steps to flush mount the RA-100:
To Next Page
Loading...
Need help?
General
