Honeywell ECS Series User Manual

Model IFP-2100/ECS Installation Manual LS10143-001SK-E
4-15
following pages.
Figure 4-19 Annunciator Parts
The RA-1000 comes from the factory fully assembled. You must disassemble it for mounting. To disassemble
the annunciator, use a 5/64 hex wrench to remove the set screws, located on the bottom of the annunciator bezel.
(See Figure 4-20 for location of the set screws.)
Figure 4-20 Annunciator Backbox and Bezel Details
Set screw location.
Loosen set screws to remove bezel
when disassembling annunciator.
Knockout holes
Holes for surface mounting.
Holes for inserting
wires for flush mounting
(located in all corners).
Stand-off
(throughout)
Screw for placement
of mounting wires
(top and bottom).

Honeywell ECS Series Specifications

General

Brand	Honeywell
Model	ECS Series
Category	Conference System
Language	English