1
Contents
Section 1
Introduction ..................................................................................................................................................1
1.1 Overview of Basic System ...........................................................................................................1
1.1.1 Hardware Features ...............................................................................................................1
1.1.2 Network System Hardware Features ....................................................................................2
1.1.3 Software Features .................................................................................................................2
1.1.4 IFP-2100ECS Features .........................................................................................................2
1.1.5 Terms Used in this Manual ...................................................................................................3
1.2 Compatible Products ...................................................................................................................3
Section 2
Agency Listings, Approvals, and Requirements .......................................1
2.1 Federal Communications Commission (FCC) .............................................................................1
2.2 Underwriters Laboratories (UL) ...................................................................................................2
2.2.1 Requirements for All Installations .........................................................................................2
2.2.2 Requirements for Central Station Fire Alarm Systems .........................................................3
2.2.3 Requirements for Local Protected Fire Alarm Systems ........................................................3
2.2.4 Requirements for Remote Station Protected Fire Alarm Systems ........................................3
2.2.5 Requirements for the Installation of Carbon Monoxide (CO) Detection and Warning
Equipment, NFPA 720 ..........................................................................................................3
2.2.6 NFPA Requirements .............................................................................................................3
Section 3
Before You Begin Installation ..............................................................................................1
3.1 Inventory ......................................................................................................................................1
3.2 Environmental Specifications ......................................................................................................1
3.3 Software Downloads ...................................................................................................................1
3.4 Electrical Specifications ...............................................................................................................2
3.5 Wiring Specifications ...................................................................................................................4
3.6 Board Assembly Diagram ............................................................................................................6
3.7 Calculating Current Draw and Standby Battery ...........................................................................7
3.7.1 Current Draw Worksheet Requirements ...............................................................................7
3.7.2 Current Draw Worksheet for IDP SLC Devices ....................................................................7
3.7.3 Current Draw Worksheet for SK SLC Devices ....................................................................11
3.7.4 Current Draw Worksheet for SD SLC Devices ...................................................................15
3.7.5 Maximum Battery Standby Load .........................................................................................19
Section 4
Control Panel Installation ..........................................................................................................1
4.1 Mounting the Control Panel Cabinet ...........................................................................................1