127
on the PATCH-FLAG. If there is a match, the system loads patches to or install them on the memory
patch area.
• In FIPS mode, you can use SFTP but not FTP or TFTP to transfer patch files.
The following table describes the default patch name for each card type.
Device PATCH-FLAG
Default
atch name
HP 5120 SI PATCH-51s patch_51s.bin
NOTE:
Loading and installation are performed on all member devices of an IRF virtual device. Before performin
these operations, save the same patch files to the root directories in the storage media of all member
devices.
One-step patch installation
To install patches in one step, use the patch install command. After you execute the command, the system
displays the message "Do you want to continue running patches after reboot? [Y/N]:"
• Entering y or Y: All the specified patches are installed, and turn to the RUNNING state from IDLE.
This equals execution of the commands patch location, patch load, patch active, and patch run.
The patches remain RUNNING after system reboot.
• Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE. This
equals execution of the commands patch location, patch load and patch active. The patches turn to
the DEACTIVE state after system reboot.
Follow these steps to install the patches in one step:
To do… Use the
command…
Remarks
Enter system view system-view —
Verify that no patches have been
installed
display patch information
Required
You can execute this command in
any view.
If no patches have been installed,
skip the next step. If patches have
been installed, move to the next
step.
Uninstall patches that have been
installed
undo patch install
Optional
You must uninstall patches that
have been installed before
installing new patches.
Install and run patches in one step patch install patch-location
Required
In FIPS mode, the patch file must
pass authenticity verification
before this command can be
executed.
To Next Page
Loading...
Need help?
General