HP 5120 series User Manual

75
User login control
This chapter includes these sections:
• User login control overview
• Configuring login control over telnet users
• Configuring source IP-based login control over NMS users
• Configuring source IP-based login control over web users
User login control overview
The device provides the following login control methods:
Lo
g
in Throu
g
h Lo
g
in control methods ACL used
Telnet
Configuring source IP-based login c
ontrol over telnet users Basic ACL
Configuring source and destination IP-based login control
over telnet users
Advanced ACL
Configuring source MAC-based login control over telnet
users
Ethernet frame header ACL
NMS Configuring source IP-based login control over NMS users Basic ACL
Web Configuring source IP-based login control over web users Basic ACL
FIPS compliance
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about
FIPS mode, see the Security Configuration Guide.
Unless otherwise noted, devices in the configuration examples are operating in non-FIPS mode.
Configuring login control over telnet users
NOTE:
This feature is not supported in FIPS mode.
Configuration preparation
Before configuration, determine the permitted or denied source IP addresses, source MAC addresses,
and destination IP addresses.

HP 5120 series Specifications

General

Brand	HP
Model	5120 series
Category	Switch
Language	English