8
Hotke
Function
Ctrl+C Stops performing a command.
Ctrl+D Deletes the character at the current cursor position.
Ctrl+E Moves the cursor to the end of the current line.
Ctrl+F Moves the cursor one character to the right.
Ctrl+H Deletes the character to the left of the cursor.
Ctrl+K Terminates an outgoing connection.
Ctrl+N Displays the next command in the history command buffer.
Ctrl+P Displays the previous command in the history command buffer.
Ctrl+R Redisplays the current line information.
Ctrl+V Pastes the content in the clipboard.
Ctrl+W
Deletes all the characters in a continuous string to the left of the
cursor.
Ctrl+X Deletes all the characters to the left of the cursor.
Ctrl+Y Deletes all the characters to the right of the cursor.
Ctrl+Z Exits to user view.
Ctrl+] Terminates an incoming connection or a redirect connection.
Esc+B
Moves the cursor to the leading character of the continuous string to
the left.
Esc+D
Deletes all the characters of the continuous string at the current
cursor position and to the right of the cursor.
Esc+F
Moves the cursor to the front of the next continuous string to the
right.
Esc+N
Moves the cursor down by one line (available before you press
Enter)
Esc+P Moves the cursor up by one line (available before you press Enter)
Esc+< Specifies the cursor as the beginning of the clipboard.
Esc+> Specifies the cursor as the ending of the clipboard.
NOTE:
The hotkeys in the table above are defined by the switch. If the same hotkeys are defined by the terminal
software that you use to interact with the switch, the hotkeys defined by the terminal software take effect.
Redisplaying input but not submitted commands
If your command input is interrupted by output system information, you can use this feature to redisplay
the previously input but not submitted commands.
Follow these steps to enable redisplaying of input but not submitted commands:
To do… Use the command… Remarks
Enter system view system-view —
To Next Page
Loading...
Need help?
General