HP 5120 series User Manual

14
user privilege level 3
#
return
2. Example of using the exclude keyword
# Display the non-direct routes in the routing table (the output depends on the current configuration).
<Sysname> display ip routing-table | exclude Direct
Routing Tables: Public
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 Static 60 2 10.1.1.2 Vlan2
3. Example of using the include keyword
# Display the route entries that contain Vlan in the routing table (the output depends on the current
configuration).
<Sysname> display ip routing-table | include Vlan
Routing Tables: Public
Destination/Mask Proto Pre Cost NextHop Interface
192.168.1.0/24 Direct 0 0 192.168.1.42 Vlan999
Configuring user privilege and command levels
To avoid unauthorized access, the switch defines user privilege levels and command levels. User privilege
levels correspond to command levels. When a user at a specific privilege level logs in, the user can only
use commands at that level, or lower levels.
All the commands are categorized into four levels: visit, monitor, system, and manage, and are identified
from low to high, respectively by 0 through 3. Table 5 de
scribes the command levels.
Table 5 Default command levels
Level Privile
g
e Descri
p
tion
0 Visit
Involves commands for network diagnosis and accessing an external device.
Configuration of commands at this level cannot survive a device restart. Upon
device restart, the commands at this level will be restored to the default settings.
Commands at this level include ping, tracert, telnet and ssh2.
1 Monitor
Involves commands for system maintenance and service fault diagnosis.
Commands at this level are not allowed to be saved after being configured. After
the switch is restarted, the commands at this level will be restored to the default
settings.
Commands at this level include debugging, terminal, refresh, reset, and send.
2 System
Involves service configuration commands, such as routing configuration
commands and commands for configuring services at different network levels.
By default, commands at this level include all configuration commands except for
those at the manage level.

HP 5120 series Specifications

General

Brand	HP
Model	5120 series
Category	Switch
Language	English