JR XP6102 User Manual

39XP6102 - Airplane Manual
Accessing the Programmable Mixing Function
1. Place the transmitter switch in the On
position.
2. Press the Down and Select keys
simultaneously to enter the Function
mode.
3. Press either the Up or Down key until
MIX 1 appears in the LCD.
Selecting the Master and Slave Mixing
Channels
4. Press the (+) or (-) keys to select the
master channel.
5. Press the Select key to move the cursor
to the slave channel position.
6. Press the (+) or (-) keys to select the
slave channel.
7. Press the Select key once. The display
will continue to show the current mixing
channels at the top of the LCD, but now
an arrow will indicate the current stick
position (master) to be adjusted.
Setting the Mixing Values
8. While holding the master stick in the
direction you want to mix, press the (+)
or (-) keys to increase or decrease the
mixing value for the slave channel. The
value in the LCD will change to display
the current mix value selected. Next,
hold the master stick to the other side to
adjust the mix for the other direction.
Setting the Mixing Switch Activation
9. Press the Channel key once again. The
LCD with "ALWAYS ON" indicates the
current switch that this mix is currently
selected to always be active (ON).
Mixing Operation and Switches
Each mixing program can be turned on
and off by a lever or switch. The levers
and switches that can be selected for
program mixing are tabulated at the right
with their abbreviations appearing on the
display and their corresponding positions.
The mix switch options are:
ALWAYS ON
RIGHT FWD
RIGHT REA
LEFT FWD
LEFT REA
AILE D/R
ELEV D/R
Setting the Mixing Channel Offset
1. Press the Select key until offset is
highlighted. The display will show the
current mixing channels at the top of the
LCD, with the word "OFFSET" in the
center of the LCD. The value to the right
is the mixing Offset neutral point,
currently 0.
2. A new value for the offset can be
selected using the (+) or (-) keys. This is
the new neutral point for the slave
channel (Point that the mix is activated).
Press the Clear key to reset the value
back to 0.
3. Press the Down and Select keys
simultaneously to exit the Programmable
Mix function.
With a little practice, programmable
mixing will become easier to
understand. Mixing is only limited
by your imagination.

JR XP6102 Specifications

General

Brand	JR
Model	XP6102
Category	Remote Control
Language	English