JR XP6102 User Manual

55XP6102 - Helicopter Manual
MODEL COPY FUNCTION
5.6
The Copy Selection function enables you
to copy all of the settings of the current
model to another model within the same
transmitter. This is very useful when setting
up one aircraft several different ways or
when trying an alternative setup of your
current model.
Accessing the Model Copy Function
1. While pressing the Down and Select
keys, move the transmitter’s power
switch to the On position.
2. Press either the Up or Down key until
MODEL COPY appears on the top left
of the LCD.
3. The upper number that appears is the
current model. This is important to note
as only the current model will be the
copied. Press the (+) or (-) keys to select
the desired program (lower number) to
copy the current model to.
4. Next, press the Clear key. The current
model will then be copied to the
selected model.
Note: Always make sure that the
accepting model is either free of
input or one which you no longer
want to retain in your transmitter’s
memory. Once the copying process
has been completed, the information
of the accepting model is lost and the
current model is input as the new
data.
5. Press the Up key to access the
MODULATION function.
6. Press the Down key to access the
MODEL TYPE function.
7. Press the Down and Select keys
simultaneously to exit the MODEL
COPY function.
[MODEL COPY]
#3 VENTURE

#2 HELI SPCM
Model number to
be copied to
Model number and name
to be copied
Perform copy
function
Go to Modulation menu
Go to Model Type menu
Change model to
copy to

JR XP6102 Specifications

General

Brand	JR
Model	XP6102
Category	Remote Control
Language	English