FX-3R Maintenance Guide
2-2
Rev. 1.00
17) Assemble the head main stay. First, push the head main stay against the bottom of the
head main base and assemble them. After that, adjust the height levels of the stay
stands L･R and Z-power connector base, and then assemble them.
The Fig. below shows the LF head. Replace other head in the same manner as
described above.
∗ Apply Loctite 242 to the head assembly screws (6 pcs.) and assemble them with a
tightening torque of 7.0N･m.
∗ After the head has been replaced, MS parameters need to be input again. For details
about input items, see section 2-7.
To Next Page
Loading...
Need help?
General
