FX-3R Maintenance Guide
ii
Rev. 1.00
3-4-1. Replacing the HMS Head .................................................................................................... 3-9
3-4-2. Replacing the Amplifier ........................................................................................................ 3-9
3-4-3. Sticking the Label............................................................................................................... 3-10
3-4-4. Adjusting the HMS Height.................................................................................................. 3-10
3-5. Replacing the Head Board ...................................................................................3-11
3-5-1. Replacing the Head Main Board ........................................................................................ 3-11
3-6. Replacing the ZT-Driver Board .............................................................................3-12
3-6-1. Replacing the ZT-Driver Board .......................................................................................... 3-12
[4] OCC ASSEMBLY ....................................................................................4-1
4-1. Replacing the OCC Assembly ................................................................................4-1
4-2. Replacing the CCD Camera and Lens ...................................................................4-2
4-3. Replacing the OCC Coaxial/Angle Light Board Assemblies ...................................4-3
4-4. Replacing the Lens Filter........................................................................................4-4
4-5. Adjusting the Focus ................................................................................................4-6
4-6. Adjusting the OCC Light Quantity...........................................................................4-7
4-7. Replacing the Solder Recognition Light Board .......................................................4-8
4-8. Readjustment After Replacement of OCC Unit.......................................................4-9
[5] BOARD TRANSPORT UNIT...................................................................5-1
5-1. Replacing the Transport Belt ..................................................................................5-1
5-2. Replacing the Transport Pulley...............................................................................5-2
5-2-1. Transport Pulley A Assembly: E21117150A0 ...................................................................... 5-2
5-2-2. Transport Pulley B Assembly: E20897210A0 ...................................................................... 5-2
5-3. Replacing the STATION, IN, OUT, and JOINT Motors...........................................5-3
5-4. Replacing the IN and OUT Sensors .......................................................................5-4
5-5. Replacing the WAIT, STOP, and C-OUT Sensors..................................................5-5
5-5-1. Replacing the Fiber.............................................................................................................. 5-5
5-5-2. Replacing the Amplifier Unit................................................................................................. 5-5
5-5-3. Adjusting the Sensitivity of the WAIT/STOP/C-OUT Sensor................................................ 5-7
5-6. Replacing the Stopper Cylinder ............................................................................5-10
5-7. Replacing the Support Table Home Position Sensor
(BU Home Position Sensor)..................................................................................5-11
5-8. Replacing the T-PIN Sensor (Optional) ................................................................5-11
5-9. Replacing the Pusher Y Cylinder (Outer Shape Reference).................................5-12
5-10. Replacing the Centering Pin (Optional) ................................................................5-13
5-11. Replacing the Support Table Motor (BU Motor)....................................................5-14
5-11-1. Adjusting the Gap between Torque Supporter and Support Motor ...................................... 5-15
5-11-2. Adjusting the Tension of the Support Table Driving Timing Belt ........................................ 5-15
5-11-3. Placing the Support Table Surface Horizontally................................................................. 5-15
To Next Page
Loading...
Need help?
General
