2: General operation Series 2600B System SourceMeter® Instrument
2-30 2600BS-901-01 Rev. B / May 2013
Setting the sink mode from the remote interface
To enable or disable sink mode from the remote interface:
The programming example below illustrates how to enable sink mode (to disable, set the attribute to
smua.DISABLE):
smua.source.sink = smua.ENABLE
Fundamental circuit configurations
The fundamental source-measure configurations for the Series 2600B are shown in the following
figure. When sourcing voltage, you can measure current or voltage (see A: Source V). When sourcing
current, you can measure voltage or current (see B: Source I). See Basic circuit configurations (on
page 4-19) for detailed information.
Figure 10: Fundamental source-measure configurations
Operation considerations for the ADC
The following paragraphs discuss autozero and NPLC caching.
To Next Page
Loading...
Need help?
General
