To Next Page

To Previous Page

Appendix

G: Model 2400 emulation Series 2600B System SourceMeter® Instrument

Reference Manual

G-16 2600BS-901-01 Rev. B / May 2013

:SENSe[1] subsystem

[:SENSe[1]]:CURRent[:DC]:PROTection:RSYNchronize <Bool>

The measurement range will only track the limit range when the output is on.

[:SENSe[1]]:FUNCtion:OFF:ALL

Reading are not taken when all the functions are turned off.

[:SENSe[1]]:RESistance:MODE MANual|AUTO

Only MANual is supported. The instrument will generate an error if AUTO is selected.

[:SENSe[1]]:RESistance:RANGe:AUTO <Bool>

The instrument will ignore this command. Resistance auto range is always OFF.

[:SENSe[1]]:VOLTage[:DC]:PROTection:RSYNchronize <Bool>

The measurement range will only track the limit range when the output is on.

:SOURce subsystem

:SOURce[1]:CLEar:AUTO:MODE ALWays|TCOunt

Only ALWays is supported. The instrument will generate an error if TCOunt is selected.

:SOURce[1]:DELay:AUTO <Bool>

This setting is not supported with source memory sweeps. Source memory sweeps will not use automatic delays.

:SOURce[1]:FUNCtion:SHAPe DC|PULSe

This setting is not supported with source memory sweeps. Source memory sweeps will always use DC.

:SOURce[1]:SOAK?

Always returns 0.

:SOURce[1]:SWEep:RANGing BEST|AUTO|FIXed

When this setting is set to AUTO, a sweep will leave the corresponding source ranging set to AUTO. This is done

each time the sweep is run.

:SOURce2:BSIZe 3|4

The 2499-DIGIO option is not supported. (16-bit size is not supported.)

Keithley 2614B Reference Manual

Other manuals for Keithley 2614B