The contents of the Call channel cannot be deleted;
however,
you
can overwrite old data with new data
as
described below.
• Changing Call Channel
Contents
(Simplex)
1 Select the desired frequency and associated data
(Tone, CTCSS, DTSS, etc.) using the VFO or
Memory Recall.
2 Press [F)
(1
s)
to
select Memory Storage.
3 Press [CALL].
• The selected frequency
and
associated data are
stored
in
the Call channel, and the previous
mode
is
restored.
• Changing Call Channel
Contents
(Split)
1 After storing the receive frequency using
"Changing Call channel contents (Simplex)"
instructions
in
the preceding section, select the
desired transmit frequency.
2 Press
[F]
(1
s) to select Memory Storage.
3 Press
[PTT]
+[CALL].
• The selected transmit frequency
is
stored
in
the
Call channel, and the previous mode
is
restored.
CHANNEL
DISPLAY
FUNCTION
When this function
is
switched ON, the transceiver
selects Memory Recall and displays only a memory
channel number instead
of
a frequency. During
emergency drills
and
emergency communications, or
when participating
in
communications for important
events, channelized operations can increase operating
efficiency and maintain security of communications if
required.
1 Press
[CALL]+
POWER ON
to
select Menu Set-up.
2 Turn the ENC/SQL control to select Menu No.
12.
• The current Channel Display status appears.
• The default
is
"OFF".
APO
rLincc
LJ1LI
I I
IC'
s
3 Press
[CALL]
to
select "OFF" or
"ON".
• OFF: Turns
OFF
Channel Display.
•
ON:
Turns
ON
Channel Display.
4 Press any key other than
{CALL],
{LAMP],
or
{MONI]
to exit Menu Set-up.
25
To Next Page
Loading...
Need help?
General
