TONE ALERT
Tone Alert provides
an
audible alarm to indicate when
someone is transmitting
on
the frequency you are
monitoring.
Tone Alert is
an
effective partner with CTCSS, Page, or
DTSS. When the correct signaling comes through, your
transceiver beeps to alert
you
of
an
incoming call from a
specific station.
ACTIVATING TONE ALERT
1 Tune to the prearranged frequency.
2 Activate CTCSS, Page, or DTSS if you want to use
these together with Tone Alert.
3 Press [F], [CALL].
48
• The "bell" icon appears.
APO
s
• Each time this key combination is pressed, Tone
Alert toggles ON
and
OFF.
4 When the correct signal is received, the transceiver
beeps and the "bell" icon begins blinking.
• The Display shows the number of hours
and
minutes elapsed after the signal was received.
After
1
00
hours pass, the displayed time resets,
and
counting continues from 00.00. Each time a
new signal is received, the time resets
to
00.00.
5 When the "bell" icon is blinking, exit Tone Alert by
pressing
[PTTJ.
• TH-22EJTH-42E: Pressing [T/CTJ also cancels this
funct1on.
Note:
~
It
Tone Alert is ON, APO does not turn the power
OFF.
._
If
Tone Alert
is
ON.
there is no speaker output except the
beep tone.
._
When
a signal is received with the Beep function
OFF,
the
"bell"
icon blinks, but
an
alarm tone
is
not generated .
..
For Tone Alert to function correctly with CTCSS, the
incoming signal must be present for approximately
1 second.
..
If
Tone
Alert is
ON,
Scan cannot
be
used.
..
For Tone Alert to function correctly with DTSS
or
Page, the
correct
code
must' accompany the incoming signals.
To Next Page
Loading...
Need help?
General
