• Canceling Automatic Offset
Automatic Offset
can
be
canceled
as
described below:
1 Press
[CALL]+
POWER ON to enter Menu
Set-up.
2 Turn the ENC/SQL control
to
select Menu
No.
07.
• The current Automatic Offset status appears.
• The default is
"ON"
for TH-22 versions sold
in
the U.S.A., Canada
and
Europe.
APO
R5
s
3 Press [CALL]
to
select "OFF" or
"ON".
•
OFF:
Cancels Automatic Offset.
•
ON
: Restores Automatic Offset.
4 Press any key other than [CALL], (LAIIIIP], or
[MONI]
to exit Menu Set-up.
Note: After turning
ON
Automatic Offset again,
or
after
transferring memory channel contents
to
the
VFO,
the
feature
resumes functioning when a new frequency
is
selected.
SELECTING OFFSET VALUES MANUALLY
To change the amount of offset, use the following
procedure:
1 Press
[F=]
(1
s), [REV].
2 Turn the ENC/SQL control
to
select the desired value.
• The values range from 0.00 MHz to 99.95
MHz
in
50 kHz steps.
3 Press any key other than
[MONI]
or
[LAMP]
to
store
the selected value.
• The previous mode is restored.
Remember the following points before .altering the offset:
• The TH-42E offset can be changed from the default
1.6
MHz value; however, the 7.6 MHz value
is
not
configurable.
• It
is
not possible
to
set different offset values for the
VFO
and
memory channels.
• The new manually selected value will be used even if
Automatic Offset
is
switched ON.
29
To Next Page
Loading...
Need help?
General
