BATTERY INFORMATION
NiCd
BATIERY
PACK (PB-32/PB-34)
You must charge the battery pack before you can use
it.
The pack is delivered uncharged to provide
you
with the
greatest number of charge/discharge cycles.
It
takes
several charge/discharge cycles before achieving the full
battery pack capacity. After storing the pack for more
than 2 months, recharge it before use.
• Recharging
Insert the plug from the BC-17 charger into the DC
IN
jack on the right side
of
the transceiver. Then plug
the charger AC plug into an
AC
wall outlet. Do not
charge the battery for more than
15
hours. Exceeding
the recommended charge period shortens the useful
life of the pack and adversely affects battery
performance.
~
DC IN
jack
'~
Note:
~
Recharging
should
be
done
within an
ambient
temperature
between soc to
40°C
(41°F
to 104°F).
Recharging
outside this
range
may
not
fully
charge
the
battery.
~
If
the entire
display
is blinking,
or
if
turning
PWR/VOL
clockwise
does
not
power
the transceiver,
recharge
the
battery
pack.
~
The
BC-17
charger
is
designed
to
recharge
only PB-32,
PB-34,
PB-30
(option),
or
PB-33
(option). Never
use
the
BC-17
to recharge
other
types
of
batteries.
• Installing/Removing the Battery Pack
Insert the battery pack into the bottom of the
transceiver, and push
in
until the tab
on
the pack
locks
in
place.
To remove the battery pack, simultaneously press the
tab on the back of the pack while pulling out the pack
from the transceiver.
3
To Next Page
Loading...
Need help?
General
