TROUBLESHOOTING
The problems described
in
this table are commonly encountered operational malfunctions. These types of difficulties
are usually caused
by
improper hook-up, accidental incorrect control settings, or operator error due to incomplete
programming,
and
are not caused by a circuit failure. Please review this table, and the appropriate section(s) of this
Instruction Manual, before assuming your transceiver
is
defective.
Problem Symptom Probable Cause Corrective Action
Nothing appears on the
1
Low supply voltage 1 Recharge the batter'{ pack or replace the
display when the batteries.
transceiver is switched ON
2
If
using optional
DC
cable:
2
a)
Check power cable and connections,
(PWRNOL control turned
a)
Bad
power cable or connections
then repair/replace
as
necessary.
clockwise), or the entire
b)
Open power supply fuse
b)
Investigate the cause for the open
display is blinking ON and
OFF.
fuse. Replace the fuse.
No
sound comes from the Noise squelch
is
closed since no stations None necessary. The speaker output is
speaker. are on frequency. muted automatically if no signals are being
received. Press
[MONIJ to override the
noise squelch and verify no stations are
on
frequency {page 13}.
Cont1nued
54
To Next Page
Loading...
Need help?
General
