Kenwood TH-22E User Manual

From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
SCAN RESUME METHODS
When using Scan, it's necessary to decide under what
condition you want your transceiver to continue scanning
after detecting and stopping for a signal. You can
choose Time-operated Scan or Carrier-operated Scan.
The default is Time-operated Scan.
• Time-Operated Scan
Your transceiver stops scanning after detecting a
signal, remains there for approximately 5 seconds,
and
then continues to scan even if the signal is still
present.
• Carrier-Operated Scan
36
Your transceiver stops scanning after detecting a
signal and remains
on the same frequency until the
signal drops out. There
is a 2 second delay between
signal drop-out and scan resumption to allow time for
any responding stations to begin transmitting.
SELECTING THE SCAN RESUME METHOD
Use the following procedure to switch your transceiver
between Time-operated Scan
and Carrier-operated Scan.
1 Press [CALL}+ POWER ON to enter Menu Set-up.
2 Turn the
ENC/SQL control to select Menu No. 03.
• The current Scan Resume status appears.
• The default is
"TO" (time-operated scan).
5[
APO
• n u":;-:~
,-,,
--
s
3 Press [CALL] to select either "TO" or "CO".
4 Press any key other than [CALL], [LAMP], or [MONJ]
to exit Menu Set-up.
Note: Holding [MONt] down while scanning halts Scan
regardless whether Time-operated or Carrier-operated Scan
is selected. Resume scanning by releasing {MONI].

Kenwood TH-22E Specifications

General

Brand	Kenwood
Model	TH-22E
Category	Transceiver
Language	English