7
Using the Utility Mode
7-8
Erase Setting (Left, Top, and Frame)
Set the erase width for each of the Left, Top, and Frame Erase copies in
the range between 5 mm and 20 mm (in 1-mm increments).
G
The default value is “10 mm” for Left, Upper, and Frame Erase.
Auto Panel Reset
Select the time it takes the auto panel reset function to be activated from
among “30 seconds,” “1 min,” “2 min,” “3 min,” “4 min,” or “5 min,” or not
activated at all.
G
The default value is “1 min.”
Power Save
Set the time it takes the copier to enter the Power Save mode, from 1 min
to 240 min (in 1-min increments).
G
The default value is “15 min.”
Auto Shut OFF
Set the time it takes the Auto Shut OFF function to be activated, from 15
min to 240 min (in 1-min increments). To disable the Auto Shut OFF
function, first “authorize” the “Disable Auto Shut OFF” under the
Administrator Mode (p.7-26) before selecting “Auto Shut OFF disabled.”
G
The default value is “30 min.”
Density (ADF)
Adjust the copy image density level when the copier is equipped with an
Automatic Document Feeder.
Mode 1: Used for the standard original, such as a word-processor made
document.
Mode 2: Effective in reproducing a pale original, such as a faint pencil-
written document.
G
The default value is “Mode 1.”
Printer Density
Select the image density level of copies and printed pages from among “-
2,” “-1,” “0,” “1,” or “2.”
The smaller the value, the lighter the image, and the greater the value, the
darker the image with “0” as the central value.
G
The default value is “0.”
Konica7115_7118.book Page 8 Tuesday, October 16, 2001 10:51 AM
To Next Page
Loading...
Need help?
General
