Precautions
2
2-1
2 Precautions
Observe the following precautions to keep the copier in the best possible
conditions.
2.1 Installation Precautions
Installation site
To ensure utmost safety and prevent possible malfunctions, install the
copier in a location that meets the following requirements:
-
A location away from curtains, etc. that may catch fire and burn easily
-
A location that is not exposed to water or other liquids
-
A location free from direct sunlight
-
A location out of the direct airflow of an air conditioner or heater, and
not exposed to extremely high or low temperatures
-
A well-ventilated location
-
A location that is not exposed to high humidity
-
A location that is not extremely dusty
-
A location not subjected to undue vibrations
-
A stable and level location
-
A location where ammonia or other organic gases are not generated
-
A location that does not put the operator in the direct airflow of exhaust
from the copier
-
A location that is not near any kind of heating devices
Power source
The power source requirements are as follows.
G
Voltage Fluctuation: Within±10%
G
Frequency Fluctuation: Within ±3Hz
❍
Use a power source with as few voltage or frequency fluctuations as
possible.
Konica7115_7118.book Page 1 Tuesday, October 16, 2001 10:51 AM
To Next Page
Loading...
Need help?
General
