Using the Utility Mode
7
7-9
Paper Auto Detection
Select “Metric” if the size of the paper loaded in each tray is designated
according to the metric system, such as A4 and B4. Select “Inch” if the
size of the paper loaded in each tray is designated according to the inch
system, such as Letter.
G
The default value is “Metric.”
Paper Size Detection
Select whether to “automatically detect” or “input size” for the paper
loaded in the 1st Tray.
G
The default value is “Automatic detection.”
Paper Type (1st Tray)
Select the type of paper loaded in the 1st Tray from among “plain paper,”
“cards,” or “OHP transparencies.”
G
The default value is “plain paper.”
Paper Type (Bypass Tray)
Select the type of paper loaded in the Bypass Tray from among “plain
paper,” “cards,” or “OHP transparencies.”
G
The default value is “plain paper.”
Special Paper Setting
All trays can generally be chosen for the APS mode. This sometimes
results in a situation in which a tray loaded with special paper is selected
for a job, which is not intended by the user. Therefore, a particular tray, if
designated for special paper, can be excluded from APS selection.
This function also allows you to specify if the designated tray is subject to
Auto Tray Switching.
APS disabled, Auto Tray Switching disabled:
Select this
option for paper that is to be used only for special purposes,
such as “colored paper” and “paper printed with a company logo.”
APS disabled, Auto Tray Switching enabled:
Select this option in cases where “you give priority to plain paper for use,”
but “you want an uninterrupted copy cycle to use recycled paper even
when plain paper runs out.”
G
The default value is “APS enabled (special paper setting OFF).”
Konica7115_7118.book Page 9 Tuesday, October 16, 2001 10:51 AM
To Next Page
Loading...
Need help?
General
