9
Troubleshooting Tips
9-4
9.2 When the Copier is not Operating Correctly
Symptom Possible Cause Action
Nothing is indicated on the
control panel.
Only the [START] key lights
green.
The copier is in the Power
Save mode. Press any key
on the control panel to leave
the mode. (p.3-18)
The Auto Shut OFF function
has been activated.
Turn OFF, then ON, the
Power Switch. (p.3-15)
The [START] key does not
light green.
An account number has not
been entered.
Enter the account number
according to the procedure
given in “To enter an account
number.” (p.3-20)
No copies are produced
even when the [START] key
is pressed.
An icon on the control panel
is lit.
Take necessary action to
correct the problem indicated
by the lit icon. (p.3-14, p.8-1)
The copier is still warming
up.
The copier takes about 30
seconds to complete
warming up after it has been
turned ON.
Keys on the control panel do
not respond.
The Interrupt indicator is lit. The copier is in an interrupt
mode. Press the
[INTERRUPT] key to leave
the interrupt mode. (p.3-19)
The copier cannot be turned
ON.
The power cord is unplugged
from the power outlet.
Plug the power cord into the
power outlet.
The room’s circuit breaker is
tripped.
Close the room’s circuit
breaker.
Konica7115_7118.book Page 4 Tuesday, October 16, 2001 10:51 AM
To Next Page
Loading...
Need help?
General
